- Past bij:
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...en meer.
Snugged it up and engine is much quieter now as it would be expected with a new ProX chain.
Automatic one was all out of adjustment and keep the chain too tight.Quality and finish is good. Came in a f...Lees verder - Past bij:
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...en meer.
The machine work is phenomenal. The fit and finish is amazing. It's a bit expensive but well worth it in regards to build quality. Love it!!Lees verder - Past bij:
- KAWASAKI
- KAWASAKI 750SS MACHIV (H2)
Used during engine overhaulI did a lot of research and PMC is the cheapest? Maybe.The feel is not bad and I recommend it.Lees verder - Past bij:
- KAWASAKI Z1000 (air-cooled) 72-78
- KAWASAKI Z1-R/Z1-RII 72-78
- KAWASAKI Z1 (900SUPER4) 72-78
- KAWASAKI Z1000 (air-cooled) 72-78
The raised edge prevents leakage.Lees verder - Past bij:
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...en meer.
The OEM Tensioner does not apply the proper pressure, so we are replacing it.The replacement itself is easy, but the adjustment must be proper or it will be an Engine Blow!If you're not familiar with ...Lees verder - Past bij:
- KAWASAKI Z1 (900SUPER4)
- KAWASAKI Z2 (750RS/Z750FOUR)
- KAWASAKI
- KAWASAKI
Compared to OEM, there are subtle differences in shape and texture that can be seen at a glance, but a beautiful engine can make it look better than a scratchy original.Lees verder - Past bij:
- KAWASAKI Z1-R/Z1-RII 72-80
- KAWASAKI Z1000 (air-cooled) 72-80
- KAWASAKI Z900 (KZ900) 72-80
- KAWASAKI Z750 (air-cooled) 72-80
- KAWASAKI Z2 (750RS/Z750FOUR) 72-80
- ...en meer.
If you use it well, it will not leak oil as much as the OEM type rubber ones. if you degrease the BALI and apply the liquid gas well, and if you reuse it, you can use it almost permanently by removing...Lees verder - Past bij:
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...en meer.
Oil leak from Tachometer port is a common disease of air cooled Z.If it starts leaking, replace it with this one.The installation is a little hard, so apply more silicon grease and make sure to put it...Lees verder - Past bij:
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...en meer.
This Nut is well thought out. If it is an aggregate tube, it is possible to fasten it even if it is different Nut somehow, but it is impossible if it is a 4-pipe exhaust system, and this Nut becomes n...Lees verder - Past bij:
- KAWASAKI Z1-R/Z1-RII 78-80
- KAWASAKI Z1-R/Z1-RII 78-80
- KAWASAKI Z1000 (air-cooled) 77-78
- KAWASAKI Z2 (750RS/Z750FOUR) 73-75
- KAWASAKI Z1 (900SUPER4) 72-75
- ...en meer.
If you want just the Washer, OEM Parts are still available.Lees verder - Past bij:
- KAWASAKI Z1 (900SUPER4)
- KAWASAKI Z2 (750RS/Z750FOUR)
- KAWASAKI
- KAWASAKI
My model: Kawasaki z900rs cafe. Material: Cast aluminum alloy. The quality and workmanship are first-rate. Effect: Make the car more silver and more retro. Purchase and installation experience: Becaus...Lees verder - Past bij:
- KAWASAKI
- KAWASAKI
- KAWASAKI Z1000 (air-cooled) 72-79
- KAWASAKI Z750-D1 (KZ750D) 72-79
It has nothing to do with this product, but the old Gasket stuck to it and it was hard to remove Large strange.The new Gasket I bought this time has no Oil leak and I am satisfied with Large change.Lees verder - Past bij:
- KAWASAKI
PMCShortOil pan purchased at the same time.I can cut and use OEM Strainer by myself, but I bought ready-made one because of the sensitive place. It was easy to install.Lees verder - Past bij:
- KAWASAKI
Oil Filter replacement is very easy but I think Filter is too expensive.Lees verder - Past bij:
- KAWASAKI
I bought this because I was concerned about the Right Bank on my ZEPHYR1100.Rumor has it that if you put it on the dynoma scene and let it measure as hard as it can, it will Engine blow.There is a cas...Lees verder - Past bij:
- KAWASAKI
Purchased at the same time as the Accessory Case of PMC. This product should be purchased by all means because there is not much Chuckie Tank installation Space in the car body.Lees verder - Past bij:
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- KAWASAKI
- ...en meer.
Oil leak & Ntilde. from Tachometer extraction part;It took me a long time to remove it, but I was able to remove it safely in the end. It took me a while to remove it, but I was able to remove it with...Lees verder - Past bij:
- HONDA CRM250 90-00
I think there should be a Parts List attached to the product that shows how many of which Gasket is included in the package. If the product does not have a way to confirm the quantity and name of the ...Lees verder - Past bij:
- KAWASAKI Z1000 (air-cooled) 72-79
- KAWASAKI Z750-D1 (KZ750D) 72-79
- KAWASAKI
- KAWASAKI
Unlike paper, it's not likely to stick, and even if it does, it's not a problem to clean up, so I think it's possible.However, the accuracy of Cutline is not so high, so you need to be careful.It's no...Lees verder - Past bij:
- KAWASAKI Z1000 (air-cooled) 72-80
- KAWASAKI Z750 (air-cooled) 72-80
- KAWASAKI Z900 (KZ900) 72-80
Very nicely and precisely made tensioner! This part looks like a work of art, especially in comparing to original cam chain tensioner. This tensioner also fits Kawasaki KZ650 and Zephyr750.Lees verder
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING