Very Good
Performance as reputedIt was a heavy OEMClutch of ZrX 1100, but it got lighter as expected.
Since it is made with high precision as a whole, the operation feeling is good and I am very satisfied.
With RCS 16, there was also a reputation that Clutch could not be cut off, so I chose RCS 17 and I set the 16-18 switch to 16, but in fact it is not a problem at all, but Clutch's point of connection is from Handlebar It's a pretty far place..
Quantity of index finger and middle finger : 2 pc fingering can be enough and its Quantity : It is light weight that can be operated with 2pc.
In this case I thought that there was no such thing as Clutch could not cut in RCS 16.
Since Switch is not attached, KOK-2002 for RCSRadial clutch master of Koken (3,800 yen) , You can reproduce the function of Kawasaki's 3 Pole Switch as it is. Even if you do not close Clutch, Cell will go around, if GEAR is in and you leave Side Stand and try connecting with Clutch, the engine stops properly.
Also, it is generally said that Chalk should be relocated because Choke Cable and Banjo bolt will interfere with car models like ZrX, if you change to Radial master, actually installing without interfering It was possible.
However, depending on my taste, when trying to make our preferred Lever height, it was necessary to rotate the Left Switch Box slightly towards you, so I cut down the fixing protrusions of the Switch box.
However, it is said that it is slightly rotated, so there is no sense of incongruity in appearance, the Blinker switch got down a little in the contrary, making it easier to operate with your thumb.
Clutch hoseLength, we are HARDY 's LOW Handlebar, but it was somewhat clear at 1085 mm, so I think that it is OK even at about 1060 mm.
As a result, there was no problem of Choke Cable interference, there was no problem with 3 Pole Switch, StandardLever had no problem of interference and it was almost ponding.View Detail