●Based on the concept of providing a suspension that can be used with assurance, this is an original suspension that has been completed through many trials and errors from planning and development to commercialization.
●In order to achieve low cost, the parts that make up the suspension are manufactured at partner factories overseas, while the final assembly, nitrogen gas injection, product inspection before shipment, and other important tasks are handled by specialized staff at U-CP's factories in Japan.
●U-CP has increased the tank capacity, increased the spring wire diameter by 1mm, and increased the spring outer diameter by 5mm, so the ride will not be too soft and fluffy.
●The upper and lower rubber bushings are manufactured in Japan, so they are resistant to deterioration and can be used just like the stock.
●The original "U-shaped" end eye is specially designed for GSX1100S KATANA, so it can be installed by bolt-on.
●The length of the mounting hole is about 355mm from the center to the center, which is about 2.5cm longer than the stock suspension.The end eye can be extended by 10mm.
●The spring preload can be full adjustable.
●Damping pressure cannot be adjusted.
●The preload adjustment wrench and hex wrench are included.