Ingebouwde ontsteker
[inhoud]
Gewijzigd bobinehuis X1 st.
90 graden plug cap X 1pc
Cap bevestiging 100mm tie-wraps X2
*Niet van toepassing op carburateurs met CDI-ontsteking.
*Omdat "Kai-Riki" is ontworpen voor een grote capaciteit van de spoel, kan het niet worden geïnstalleerd in de bestaande voorraadrol positie.
*Afhankelijk van de plaats van installatie kan het nodig zijn om de kap aan te passen.
*Aangezien "Kai-Riki" een ingebouwde ontsteker heeft, kan een ontsteker van het type dat de primaire spanning van de spoel verhoogt niet samen worden gebruikt.
*De A/F-waarde zal worden verdund, zelfs als je alleen "Kai-Riki" gebruikt. Verhoog de hoeveelheid indien nodig met behulp van een brandstofregelaar.
*Controleer de toestand van de bougie en stel de warmtewaarde in.
Built-in Igniter
[Components]
・Modified power ignition coil body x 1pc
・90 degree plug cap x 1pc
・Cap fixing 100mm cable-tie x 2
*This product is not compatible with carburetor vehicles with CDI ignition.
*"KAIRIKI" can not be installed in the existing stock coil position because of the large coil large capacity design.
*Depending on the installation location, modification of the cowl may be required.
*Since "KAIRIKI" has a built-in igniter, the igniter of the type that boosts the primary voltage of the coil cannot be used together.
*Even if you use "KAIRIKI" by itself, A / Fga will be diluted, so if necessary, increase the amount by fuel controller.
*Check the condition of the spark plug and adjust the heat value.