*Dit product is ongeveer 65 mm naar achteren en 3 mm lager in hoogte dan de standaard handgreep.
*De totale breedte is -5mm aan het eind van de standaard hendel. (Totale breedte:±20mm/ totale hoogte:±40mm) Er is geen structurele verandering nodig.
*Het is niet nodig de slang/kabels voor dit product te vervangen, maar als u zich daar zorgen over maakt, kunt u de remslang op de juiste lengte brengen. Gelieve de spanning van de asdraad aan te passen wegens de verandering in behandeling.
*Er is een fout in de dikte van de verf op dit product. Als je de askant omdraait, kan hij dof zijn. In dit geval moet de kant van de gashuls van het stuur worden aangepast door met een vijl te schaven.
*De ponsmerken op dit product dienen alleen ter referentie. Stel de positie van het handvat naar uw wens in.
*Het is mogelijk dat het gat in de schakelkast van dit product niet helemaal goed uitgelijnd is. In een dergelijk geval kan het nodig zijn het te wijzigen door het gat te verbreden. Als u een persoon bent die kieskeurig is over de bolt-on installatie, of u zenuwachtig bent over de arbeidskosten en het proces, adviseren wij u om vooraf met Honda Dream shop te overleggen.
*Er is een geval dat er een specificatiewijziging van de grondstof is door het gemak van de fabrikant. Begrijp alsjeblieft.
[Size*] W: 710 H: 100 R: 200 L: 130
[Handle diameter] 1 inch (25.4mm)
*W (Overall width) H (Height) R (Amount of pullback) L (Clamp section straight) Unit (mm)
*This product is approximately 65mm back and 3mm lower in height than the stock handle.
*Overall width is -5mm at the end of the stock lever.(Full width: ±20mm / height: ±40mm) No structural changes are required.
*This product does not require any changes to the hoses / harnesses / wires, but if you are concerned, please change the brake hoses to an appropriate length.Adjust the tension of the axle wire due to the changes in handling.
*The thickness of the paint on this product may vary.There may be a dullness when turning to the axle side.In this case, it is necessary to adjust the throttle sleeve side of the handlebar by shaving with a file.
*The punch marks on this product are for reference only.Please adjust the position of the handlebar to your liking.
*The holes in the switch box of this product may be slightly out of alignment.In this case, it is necessary to widen the hole.If you are a person who is finicky about bolt-on installation, or if you are nervous about the labor cost and process, it is recommended that you consult with your HONDA Dream shop beforehand.
*There may be changes in product specifications due to the manufacturer's reasons.