Het is een driedimensionaal embleem dat kan worden bevestigd aan brandstoftank, zijdekking. Als één punt bijlage.
Body heeft Materiaal: Plastic is geadopteerd, Plating wordt op het oppervlak van het personagedeel aangebracht.
Embleem Dubbelzijdig plakband voor een sterke buitenkant is op de achterkant geplakt.
Er zijn twee soorten platen: zilver en goud, twee soorten LargeSmall worden aan elke hoeveelheid toegewezen: 2pc. Set by four, total amount: 1 Set.
[Ad Vise]
We hebben een sterk hechtende zitting, dus controleer de positie ruim voordat je het werk gaat plakken.
Als er vocht, olie, stof en was aanwezig is, is de hechting extreem slecht, dus maak de hechtingsoppervlakken grondig schoon en ontvet ze grondig.
Omgeving met lage omgevingstemperatuur (5 graden of minder) Om de initiële hechtkracht te versterken, moet u na het licht opwarmen van de zelfklevende zitting werken.
Druk na het plakken goed vanaf de bovenkant om de hechting te versterken. Was of regen niet gedurende 1 of 2 dagen na het plakken.
This is a three-dimensional emblem that can be attached to the gas tank, side cover, etc. as a one-point accessory.
The body is made of plastic, and the surface of the letters is plated.
Strong exterior double-sided tape is attached to the back of the emblem.
Plating is available in silver and gold.Two large and two small, total 4 pieces per set.
[Advice]
The strong adhesive sheet is used, so please check the position of the adhesive sheet carefully before installation.
If there is water, oil, dust, or wax on the surface, the adhesive strength will become extremely poor, so be sure to thoroughly clean and degrease the adhesive surface.
When working in a low temperature environment (below 5 degrees Celsius), warm up the adhesive sheet a little before working in order to strengthen the initial adhesive strength.
After pasting, please press well from the top to strengthen the adhesive force.Please do not wash your car or drive in the rain for 1 or 2 days after application.