helmslot

The fitment is good, blends in with the car body and is unobtrusive.
I think the price is right and it's just what I need.

Putting Helmet on Mirror is undesirable because of theft risk, falling risk, deterioration of Helmet interior, and so on.
I think the Helmet lock retrofit is a must for the GSX-R125.
As shown in other Review, when I lock Helmet of SHOEI, Ring is Small and I feel that it is difficult to hook it to Holder. It might need attention in the hand.

I guess it's neither possible nor impossible.

There is a Helmet lock function on the body of the vehicle.
To be honest, I can't tell where it is without looking at the Instruction Manual.
If you know how to use it, you can't use Large Helmet.
I think the addition of the Helmet lock is a must for the GSX-S125.

So I got a KIJIMA Helmet lock.
I have never used Helmet lock on any other product or any other car body.
This was my first Helmet lock, so I have no way to compare.
So the feeling of use is "Oh, so this is the Helmet lock." It is
However, I feel gratitude for Helmet lock even if it only solves the trouble of carrying Helmet and the anxiety only to put it on Mirror.

It is a type that attaches to the Tandem Footpeg, and the installation itself is a set of tools sold in the Home center etc. Quantity:I think it is possible for anyone with Set.
When you remove the Tandem Footpeg, it is a little hard, so be careful not to lick the Bolt or Wrench.
It can be installed in between lunch breaks at work.

If you don't care about high quality and you want Helmet lock first, it's possible.

It is difficult to hang D Ring of MicroRatchet of SHOEI Full face though I installed it.
It was scratched by dropping Helmet and failing to hang on the nail once.
Since then I have been using Helmet Lock Assist 2 KIJIMA:KIJIMA item number:P00033.
It's surprisingly hard to use and atrocious.
Not with this type of car.

Its fitmen is excellent!Like oem fit. It's not difficult to install. After you remove two bolts, you can assemble them with the tandem bar. Lastly, you just have to turn on the lock and tighten the screw. It has a good sense of lock and a good finish.

I'm a person who doesn't like to put a Helmet on Mirror that I've taken off (and had it stolen once) (Because there is...)
It's a bit of a hassle to carry it around with you every time you get off the bike, though

So, until now, we've basically had the Rear Sets on every motorcycle I was using a HelmetHook, but this Motorcycle (GSX-S125/ (R125) is very difficult to use..
The Hook is a bit too short to thread the D Ring of the Helmet, and the Hook It is also attached to the Seat side (not the body side)
I'm sure the Helmet will fall off someday sooner or later I've been feeling that this is a good time to introduce it

The Left SideTandem stay is removed once and tightened together with the It's not difficult
In the manual It has a screw lock and it's hard but it doesn't have a Screw Lock, and even though it's tightened up so tightly, it's not There was not

The feel is fine
The key is Quantity:It comes with 2pc, but you can lose both of them "Repair parts" You can also purchase a single body with a key as well
(Not every key has an ID, but every groove is a quantity:Pair (for Left and Right) (Only two types in different positions)
However, the opposite is true "Key Single Body Only, Easy to Buy If someone else in Red has the same KIJIMA Helmet lock key, they can The key may be used to open the door
therefore Security I think it's a bit unsuitable for those who want to
the last "We'll hang it from the body temporarily I think it's best to recognize this as a thing

Despite this, it's still very convenient to hang it on your motorcycle! It is